A bucket-conveyorised plant driven by a motor that throws metallic waste into a centrifuge of 5 kg capacity. The centrifuge extracts oil from the metallic waste through centrifugal force and stops automatically on a timer. The dry waste falls and collects in a bin, and the whole cycle repeats automatically from the electrical control panel.
Plant type Automatic oil extraction plant, bucket conveyorised
Drive Motor driven conveyor and centrifuge
Centrifuge capacity 5 kg per charge
Extraction method Centrifugal force
Cycle control Timer, with automatic stop
Cycling Fully automatic via electrical control panel
Waste discharge Dry metallic waste into collection bin
Throughput Kg per hour — to be confirmed
Motor rating To be confirmed per model
Oil recovery routing To filtration plant or holding tank
Bin capacity To be confirmed per model
Body Fabricated steel frame with oil containment base
Power supply To be confirmed per model
Plant dimensions To be confirmed per model
Customisation Conveyor, capacity and cycle sized to your swarf volume
Metal chips leaving a machining centre are soaked in cutting oil. When that swarf goes into a scrap bin, the oil goes with it — you pay for the oil, you pay to dispose of a wet mixture, and you get a lower price for contaminated scrap.
Centrifuging the swarf separates the two. The oil comes back for filtration and reuse, the metallic waste leaves dry and sells as clean scrap, and the mess of oil-soaked chips sitting in a bin next to the machine disappears.
The bucket conveyor charges the centrifuge, so no one is shovelling wet swarf by hand.
Centrifugal force pulls oil out of the metallic waste far more completely than draining ever will.
The centrifuge stops itself on a timer, so the cycle is the same every charge.
The electrical control panel repeats the whole cycle, so the plant runs unattended.
Waste leaves dry and collects in a bin, which raises its scrap value and cuts disposal cost.
Extracted oil goes to filtration and back into service instead of leaving with the scrap.
Tell us your swarf volume per shift and the oil you use. We will size the plant and estimate what the recovered oil is worth.
